Author Topic: How do I mold 1/4” hdpe to my hull? (Read 742 times)

Drenthe · « **on:** June 29, 2019, 08:08:05 PM »

My hull is a mess. Most of the wear is on the bulge below the air bladder. I have a sheet of hdpe and am trying to figure out how to mold it to that bump. I don’t want to apply to much heat for fear of damaging the hull.

Drenthe · « **Reply #1 on:** July 01, 2019, 02:32:57 PM »

I used an infrared lamp to heat the hdpe and then hoped to apply it to the bottom of the kayak. As you can see in the first pic my attempt was a failure. It curls when heated. My second attempt got better results. Less heat and more pressure while it was directly on the hull.

Painlesstom · « **Reply #2 on:** July 01, 2019, 03:16:52 PM »

There was no need to mold it to that shape, the bottom is supposed to be flat and that bulge shouldn't have been there in the first place.

Drenthe · « **Reply #3 on:** July 01, 2019, 06:01:49 PM »

Now you tell me!

I think I can fix that. Thanks Tom.

Painlesstom · « **Reply #4 on:** July 01, 2019, 06:04:08 PM »

Sorry... Somehow I missed your post until today. Been a busy weekend!

Author Topic: How do I mold 1/4” hdpe to my hull? (Read 742 times)

Drenthe

How do I mold 1/4” hdpe to my hull?

Drenthe

Re: How do I mold 1/4” hdpe to my hull?

Painlesstom

Re: How do I mold 1/4” hdpe to my hull?

Drenthe

Re: How do I mold 1/4” hdpe to my hull?

Painlesstom

Re: How do I mold 1/4” hdpe to my hull?